Operation Manual

Remove the protection covers from the pipes. Be carefull that dirt

doesnotenterthepipes.Thiswillcause

damage to the hydraulic system.

Be sure that the pipes are tted straight into the system.

Do not use any tools for mounting the pipes, light pressure is

enough to t the pipes into the system.

g. 11

Thepictureshowsclearlythattheoddnumbersarettedat

the top and the even numbers at the bottom of the distribution

block.Thepipesaremarked11-12-13and14.(See g. 12).

When the pump has been installed, you must check if the system

is not leaking. Connect the red + and the brown – cables of the

hydraulic pump on the battery. Connect the green or yellow cable

to the positive + pole of the battery to activate the pump unit.

Let the hydraulic pump run for a couple seconds this will bleed

the system automatically and to check if the pipes are not leaking.

g. 12

g. 10

To remove the transportation blocks, unscrew the bolts A as

shown on the picture (see g. 10), using the proper wrench.

Be sure no dirt is coming in the intakes. This may damage

the system. Turn the bolts out completely, to remove the

transportation blocks.

Check if the total system has been installed properly!

