Operation Manual

Installation of the Easymatic version

4. HYDRAULIC SYSTEM

g. 7

The hydraulic pipes have to be tied up to the chassis and the

caravanoor.

Take care while bending the pipes. Be sure there are no kinks

in the pipes, this will damage the pipes (see g. 7).

Do not

kink

the pipes

Install the hydraulic pump in the middle of the cara-

van oor underside. Smear a small amount of glue on the

wooden multiplex plate (15x15 cms) and screw it against the

caravan oor underside, on the previously selected location. Fix

the hydraulic pump against the wooden plate.

Be sure that the hole in the pump cover is corresponding

with the pressure release valve on the pump. In case of a

malfunction, the pressure release valve can be operated

through this hole. Don’t exceed 1/4 of a turn of the pressure

release bolt. The pressure will be released and the drive

rollers can be pushed back from the tyres.

g. 8

Lead the pipes and the electric cables through the holes of the

pumpcoverandxthemagainstthecaravanoorunderside,freeof

moving suspension parts.

Be sure when closing the cover, that the pipes are free and

not squeezed or knicked.

g. 9

Electr.leads

Release valve



Release valve