User guide

DC 900-1338I 57
Chapter
4
ICP Download,
Configuration,
and Initialization
Section 4.1 of this chapter describes additional download considerations not covered in
the Freeway User Guide or the embedded ICP user guide so you can download the tool-
kit protocol software with or without the Software Development Systems (SDS) debug
monitor. Section 4.2 describes configuration and initialization issues. Section4.3
describes the relationship between the system configuration and OS/Impact’s memory
requirements and performance.
4.1 Download Procedures
4.1.1 Freeway Server Download Procedure
The protocol software toolkit installation procedure is described in the Freeway User
Guide. On UNIX systems, all subdirectories are installed by default under the directory
named
/usr/local/freeway. On VMS systems, all subdirectories are installed by default
under the directory named
SYS$SYSDEVICE:[FREEWAY]. On Windows NT systems,
all subdirectories are installed by default under the directory named
c:\freeway. It is
highly recommended that you use these default directories.
During the software installation, boot, and test procedures described in the Freeway
User Guide, the non-debug version of the toolkit software is downloaded to the ICP.
However, during toolkit application development, you must modify your Freeway
server boot configuration file and then reboot the Freeway server to download and start
the debug monitor module. Section 4.1.1.1 and Section 4.1.1.2 describe the files and
modifications required to download with or without the Software Development Sys-
tems (SDS) debug monitor.