User`s guide

24 DC 900-1406E

BSCTRAN Programmer’s Guide

2.1.3 Important Considerations for Freeway Server

Note the following important considerations before using BSCTRAN in a Freeway

server. These notes assume that you have read the previous sections.

• Check to make sure that the supplied DLI and TSI conﬁguration ﬁles, dlitrancfg

and tsitrancfg, are set up to meet the needs of your system. Note especially:

• If your Freeways are not named freeway0 and freeway1, you need to supply

the correct server names in the

tsitrancfg ﬁle (see Section 7.2 on

page 107).

• If you have more than two Freeways, you need to add appropriate session

deﬁnitions to the

dlitrancfg ﬁle, and appropriate connection deﬁnitions to

the

tsitrancfg ﬁle.

• When using the BSCTRAN commands, you must use the appropriate server

pointers in the

server parameter. The default server pointers are FWY0 and FWY1

which point to the default server names of freeway0 and freeway1, respectively.

• You can use values other than FWY0 and FWY1 for the server pointers in BSCTRAN

commands. However, if you do so, you need to modify the session names in the

dlitrancfg file. For example, if you want to use SERVERX instead of FWY0 in the

BSCTRAN commands, you need to change session names as follows:

FWY0B0L0 to

SERVERXB0L0, FWY0B0L1 to SERVERXB0L1, and so on. The server pointers must be

4 to 10 characters in length.

• If you modify the dlitrancfg or tsitrancfg ﬁles, you must regenerate the binary

versions of the ﬁles (

dlitrancfg.bin and tsitrancfg.bin). For a detailed

description DLI and TSI conﬁguration ﬁles, see the Freeway Data Link Interface

Reference Guide and the Freeway Transport Subsystem Interface Reference Guide

• Do not change the names of the dlitrancfg and tsitrancfg ﬁles.