User guide

96 DC 900-1333P
Freeway User Guide
The Freeway Interactive Menu is then displayed. Chapter 4 describes the Interactive
Menu in detail. You can change the Freeway user name and password as described in
Section 4.5.2 on page 154.
Freeway software installation is now complete. The next section describes additional
procedures.
2.7 The Next Steps
After you have successfully performed the software installation procedures described in
this chapter, proceed as follows:
• For all protocols except the example server-resident application, run the loopback
test using the same computer you configured as the boot server and used for the
Freeway software installation. Refer to the document Freeway Loopback Test Pro-
cedures (DC 900-1533). The loopback test for the example SRA runs automati-
cally when Freeway is booted.
• Read Chapter 3 to determine whether you need to customize your system config-
uration. If you have installed more than one protocol, you can customize your
installation and run the loopback tests for the additional protocols. Customiza-
tion is not necessary at most sites.
• You can use the Freeway local console to display or customize server parameters
or perform server operations. Alternatively, you can access the Freeway Interactive
Menu using telnet or rlogin from the boot server or any other computer on the
network.
• Familiarize yourself with Freeway operations as described in Chapter 4.
• Connect the WAN cables. Your Freeway server is ready to communicate with its
client computers.