User guide

2: Software Installation
DC 900-1333P 55
If you are installing DDCMP, protocol toolkit, or X.25 on Freeway 1100/1150/
1200/1300, skip to Step 3. The electrical interface for DDCMP and protocol toolkit is
specified when you run the loopback test. The electrical interface for X.25 is specified in
the
.setup file in the freeway/client/test/x25mgr directory.
If you are installing AWS, BSC, or FMP on Freeway 1100/1150/1200/1300, change to the
freeway/client/test/ppp directory. Specify the electrical interface by editing the data link
interface (DLI) configuration files listed in Tab le 2–4.
Open each file and locate each occurrence of
ElecInterface. Remove the double slashes
(
//) from the beginning of each ElecInterface line. If you will not be using the default
EIA-232 electrical interface, replace
EIA232 with one of the following:
• EIA449
• EIA530
• V35
Step 3: Run the make file
From the
freeway/client/test/ppp directory, enter one of the following commands
depending on the system you are using. The newly created files will be placed in the
free-
way/client/op-sys/bin
directory.
make -f makefile.dec all (for a DEC UNIX system)
make -f makefile.hpux all (for an HP/UX system)
make -f makefile.sgi all (for an SGI system)
Table 2–4: Client DLI Configuration Files (UNIX)
AWS BSC3270 BSC2780/3780 FMP
awsaldcfg bsc3270aldcfg bsc3780aldcfg fmpaldcfg