User guide

2: Software Installation

DC 900-1333P 47

5. If you will be using the server-resident application (SRA), uncomment the lines

sra_module = sraxxx.o

and sra_entry = sraInit to load and run the example SRA soft-

ware at boot time. Also modify the

tsi_config_file parameter to use the muxcfg.sra

file.

Step 2: Edit the load file (

pppload)

Freeway server release G (and later) installs the XIO image files in the

freeway/boot direc-

tory. Prior to June 1, 1998, the XIO image files were distributed in the

freeway/icp-

code/icpxxxx/osimpact

directory. As a result, the load files provided with protocols with a

release date prior to June 1, 1998 contain a fully qualified path for the protocol and XIO

image files. Such files should be modified to remove the path to the XIO image. This

allows the Freeway to boot the local copy of the XIO image provided in the

boot direc-

tory with the current Freeway server release.

Edit the load file (

freeway/boot/pppload) for your protocol or toolkit as follows:

1. Uncomment the lines associated with the type of ICP in your Freeway.

2. Modify path names as needed. If no path name is provided, Freeway searches the

System Boot Directory specified in the Freeway System Boot Parameters menu

(Figure 4–27 on page 149) for the file to be loaded.

3. Do not change the memory locations (such as

40001200) for the LOAD com-

mands.

For example, to modify the

bscload file to load the BSC protocol on an ICP6000, uncom-

ment the lines associated with the ICP6000 as shown in Figure2–2.

1. xxx = 486 for Freeway1100/1150/1200/1300, 68K for a Freeway 2000/4000/8800 with an MVME 162

CPU, or

ppc for a Freeway 2000/4000/8800 with an MVME 2600 CPU.