User guide

46 DC 900-1333P

Freeway User Guide

The download_script parameter in the boot configuration file defines the path name of

the load file. The load file contains the commands that download the protocol or pro-

tocol toolkit software to the ICP.

cd /usr/local/freeway/boot

Step 1: Edit the boot file (bootcfg.xxx)

For a Freeway 1100 with both ICP2424 and ICP2432 boards installed, merge the

bootcfg.isa and bootcfg.pci files to form a new configuration file, including the physical

parameters for each ICP installed in your Freeway. Be sure that only one instance of

each

device_name is used in this file.

Edit the boot configuration file (

freeway/boot/bootcfg.xxx

) as follows:

1. Uncomment the physical parameters associated with each ICP in your Freeway.

2. For all Freeways, modify the

slave_address entry of each ICP to match your config-

uration. For Freeway 1150/1200/1300, also modify the

bus_number entry of each

ICP. Appropriate slave addresses (and bus numbers where applicable) are shown

in a table at the beginning of the boot configuration file.

3. Modify the name of the load file in each

download_script entry to match your pro-

tocol or toolkit (for example,

x25load or sraload).

4. If you have moved the load file from the

boot directory, enter the path name for

the load file in each

download_script entry. If no path name is provided in the

download_script entry, Freeway searches the System Boot Directory specified in the

Freeway System Boot Parameters menu (Figure 4–27 on page 149) for the load

file indicated.

1. Freeway 1100 uses bootcfg.isa (ICP2424) or bootcfg.pci (ICP2432). Freeway 1150/1200/1300 uses

bootcfg.pci. Freeway 2000/4000/8800 uses bootcfg.vme. Any Freeway using ICP_IP virtual ICP devices may

use

bootcfg.ip.