User guide

36 DC 900-1333P
Freeway User Guide
Step 2: Select a system name and Internet address for the Freeway server and enter
them on a line in the
hosts files of the Freeway boot server and any LAN network device
that will be communicating with Freeway. If you have more than one Freeway server,
enter one line for each server. In the sample
hosts file in Figure2–1, two Freeway servers
have been defined. The first has an Internet address of
192.168.45.6 and a system name
of
freeway1. The second has an Internet address of 192.168.45.7 and a system name of
freeway2.
If your Freeway server has multiple LAN interface boards (for example, dual Ethernet),
enter a line for each board in the
hosts file of any LAN network device that will be com-
municating with that board. Although this step is required only if you wish to assign a
logical name to each LAN interface, it is recommended to ensure that the Internet
address of each board is reserved for its exclusive use. No two LAN interface boards
within a Freeway may be configured to operate on the same sub-network.
Step 3: Write down the Internet address and system name for both Freeway and the
boot server.