User guide

4: Operations
DC 900-1333P 151
Processor Number This parameter is the number of server processors in the Freeway
server minus one. Currently, a Freeway server can support only one
server processor. The only valid number for this parameter is 0.
FTP User Name If booting from the boot server, Freeway uses this name to log in to its
FTP (or RSH). The default is
freeway. This is not required if you are
booting from the local disk.
FTP Password If booting from the boot server, Freeway uses this password to log in to
its user account. The default is
password. This parameter is optional. If
a password is given, FTP is used during system boot; if it is cleared, the
remote shell (RSH) protocol is used.
Flags This parameter specifies whether you want Freeway to:
• Autoboot two seconds after system reset, seven seconds after
system reset, or not at all
• Display the version numbers of the .mem files
• Force the primary boot network interface to operate at 10
megabits/second, half duplex
Enter the Flags value shown in Tab l e 4–2 on page153 that matches
your configuration requirements. The default
Flags value is 0. The
Flags word is an inclusive “OR” of the desired bits for the individual
functions.
Freeway Server Name Enter the system name assigned by the system administrator for this
Freeway.
Freeway Inet Address Enter the Internet address assigned by the system administrator for
this Freeway in decimal dot notation (for example, 207.67.135.84).
Freeway Subnet Mask If your Freeway is located on a subnet, enter the subnet mask in hexa-
decimal format (for example, ffffff00).
Boot Server Name Enter the name assigned by the system administrator for the boot
server. Optionally, you can clear this field and the software will assign
the default name “
bootserver.” See Section 2.1.3 on page 34. If you are
booting from the local disk, this parameter is ignored.
Boot Server Inet Address Enter the Internet address assigned by the system administrator for the
boot server in decimal dot notation (for example, 207.67.135.84). If
you are booting from the local disk, this parameter is ignored.
Table 4–1: Freeway System Boot Parameter Descriptions (Cont’d)
Boot Parameter Description