User guide

4: Operations
DC 900-1333P 131
4.4.3.1 Display IP Network Interface Information
To display the IP network interface information as shown in Figure4–9, enter ‘2’ at the
Display Network Information menu. This figure shows the display for a Freeway 1100
booting from the primary Ethernet interface. “elt” in the figure refers to the interface
type as defined in the Boot Device parameter of the System Boot Parameters menu
described in Section 4.5.1 on page 153. Network information for all attached interfaces
is displayed, including the boot device as well as any additional interfaces specified with
the
added_interface_type parameter in the boot configuration file. .
Figure 4–9: Display IP Network Interface Information
IP Network Interface Information
--------------------------------
elt (unit number 0):
Flags: (0x63) UP BROADCAST ARP RUNNING
Type: ETHERNET_CSMACD
Internet address: 207.67.135.28
Broadcast address: 207.67.135.255
Netmask 0xffffff00 Subnetmask 0xffffff00
Ethernet address is 00:60:97:81:82:e3
Metric is 0
Maximum Transfer Unit size is 1500
14025 packets received; 153 packets sent
13841 multicast packets received
0 multicast packets sent
0 input errors; 0 output errors
0 collisions; 0 dropped
lo (unit number 0):
Flags: (0x8069) UP LOOPBACK MULTICAST ARP
RUNNING
Type: SOFTWARE_LOOPBACK
Internet address: 127.0.0.1
Netmask 0xff000000 Subnetmask 0xff000000
Metric is 0
Maximum Transfer Unit size is 32768
0 packets received; 0 packets sent
0 multicast packets received
0 multicast packets sent
0 input errors; 0 output errors
0 collisions; 0 dropped
Press RETURN to continue