Installation guide

58 DC 900-1537B

Freeway 1200/1300 Hardware Installation Guide

Step 7:

After you have entered the last parameter (

Gateway Inet Interface), the screen displays:

Save modifications?

Enter 'yes <return>' to save modifications.

Enter 'no <return>' to prevent modifications.

If all of the parameters have been entered correctly, enter yy

; otherwise, enter nn

If you enter

, the screen displays the following message, and the system returns to the

Freeway Boot System Main Menu after data storage completes:

<<< Storing Data to IDE Disk >>>

If you enter

, the system returns to the Freeway Boot System Main Menu with no

modiﬁcations to the boot parameters.

Table 4–2: Flags for Reset Action

Flags Parameter Value Boot Protocol and Reset Action

0x0000 (default) Upon system reset, wait 7 seconds before autobooting.

0x0004 Upon system reset, display the Freeway Boot System Main Menu.

Do not autoboot.

0x0008 Upon system reset, wait 2 seconds before autobooting.

0x1000 Display version numbers of .mem ﬁles downloaded to an ICP

during boot. The Flags word is an inclusive “OR” of the desired bits

for the individual functions; for example, 0x1008 waits 2 seconds

before autobooting and displays the version numbers.

0x2000

Force primary boot network interface to operate at 10 megabits/

second, half duplex. The Flags word is an inclusive “OR” of the

desired bits for the individual functions; for example, 0x2008 waits

2 seconds before autobooting and forces the 10 megabits/second

speed.

11-03-99: Per

Ron Tabor,

0x2000 is for

Freeway only

at this time.