Installation guide

4: Conﬁguring the Boot Parameters using the Local Console

DC 900-1537B 53

Step 2:

Conﬁgure the console terminal to operate with the following communications param-

eters:

• 9600 bits per second

• 8 bits data

• 1 stop bit

• No parity

• xon/xoff enabled

Step 3:

Turn the power switch on the front panel on.

Step 4:

When prompted on the console screen, press <return> within 7 seconds to prevent the

autoboot attempt. The Freeway Boot System Main Menu shown in Figure 4–1 appears.

Note

The Freeway Boot System Main Menu is only accessible using the

local console connected to the rear of the Freeway unit. Later you

can access these same functions from any remote console using the

Freeway Interactive Menu as described in the Freeway User

Guide.