Installation guide

50 DC 900-1537B
Freeway 1200/1300 Hardware Installation Guide
Step 5:
After Freeway boots successfully, remove the initialization disk from the floppy drive.
Note
After the initial system boot, you can telnet or rlogin to Freeway
from the boot server (or from any other computer on the network)
and use the Freeway Interactive Menu for Freeway operations as
described in the Freeway User Guide.
You can use the Freeway Interactive Menu to modify the boot parameters. If, however,
Freeway is booted with the boot parameter initialization disk in the floppy drive, any
boot parameters that were modified using the Freeway menu will be overwritten by the
values in the
bootparm.txt file on the initialization disk.
Step 6:
Run the loopback test to check the hardware and software installation as described in
the Freeway Loopback Test Procedures.
Step 7:
If Freeway will normally boot from the boot server, installation is complete. If Freeway
will boot from its local disk, you must download the files from the boot server onto the
local disk. Follow the instructions in the Build Hard Disk from Boot Server section in
the Freeway User Guide.