Installation guide

3: Configuring the Boot Parameters using the Initialization Disk
DC 900-1537B 47
Configuration File Name This parameter contains the file that Freeway uses to configure the
physical devices and services. Enter the file name for your Freeway. The
default is bb
bb
oo
oo
oo
oo
tt
tt
cc
cc
ff
ff
gg
gg
..
..
pp
pp
cc
cc
ii
ii
. For any Freeway using ICP_IP virtual ICP
devices, the default is
bb
bb
oo
oo
oo
oo
tt
tt
cc
cc
ff
ff
gg
gg
..
..
ii
ii
pp
pp
..
..
Secondary Network
Interface
If the Boot Device is a local area network device (boot server), the
Secondary Network Interface parameter should be cleared, which is
the default.
If the Boot Device is the hard or flash disk, this parameter specifies the
local area network device to be used after Freeway boots. Set this
parameter to ff
ff
ee
ee
ii
ii
to use the primary Fast Ethernet (on the CPU board)
or ff
ff
ee
ee
ii
ii
11
11
to use the secondary Fast Ethernet board.
Gateway Inet Interface If your Freeway and boot server are on the same network, clear this
parameter, which is the default. If they are on different networks, enter
the IP address of the gateway processor on the Freeway’s network that
provides access to the boot server’s network.
Table 3–2: Flags for Reset Action
Flags Parameter Value Boot Protocol and Reset Action
0x0000 (default) Upon system reset, wait 7 seconds before autobooting.
0x0004 Upon system reset, display the Freeway Boot System Main Menu.
Do not autoboot.
0x0008 Upon system reset, wait 2 seconds before autobooting.
0x1000 Display version numbers of .mem files downloaded to an ICP
during boot. The Flags word is an inclusive OR of the desired bits
for the individual functions; for example, 0x1008 waits 2 seconds
before autobooting and displays the version numbers.
0x2000
Force primary boot network interface to operate at 10 megabits/
second, half duplex. The Flags word is an inclusive OR of the
desired bits for the individual functions; for example, 0x2008 waits
2 seconds before autobooting and forces the 10 megabits/second
speed.
Table 3–1: Freeway System Boot Parameters (Cont’d)
Boot Parameter Description
11-03-99: Per
Ron Tabor,
0x2000 is for
Freewqy only
at this time.