Installation guide

46 DC 900-1537B

Freeway 1200/1300 Hardware Installation Guide

Flags

This parameter speciﬁes whether you want Freeway to:

• Autoboot two seconds after system reset, seven seconds after

system reset, or not at all

• Display the version numbers of the .mem ﬁles

• Force the primary boot network interface to operate at 10

megabits/second, half duplex

Enter the Flags value shown in Table 3–2 on page 47 that matches your

conﬁguration requirements. The default Flags value is 0. The Flags

word is an inclusive “OR” of the desired bits for the individual func-

tions.

Freeway Server Name Enter the system name assigned by the system administrator for this

Freeway.

Freeway Inet Address Enter the Internet address assigned by the system administrator for

this Freeway in decimal dot notation (for example, 207.67.135.84).

Freeway Subnet Mask If your Freeway is located on a subnet, enter the subnet mask in hexa-

decimal notation (for example, ffffff00).

Boot Server Name Enter the name assigned by the system administrator for the boot

server. Optionally, you can clear this ﬁeld and the software will assign

the default name “bootserver.” If you are booting from the local disk,

this parameter is ignored.

Boot Server Inet Address Enter the Internet address assigned by the system administrator for the

boot server in decimal dot notation (for example, 207.67.135.84). If

you are booting from the local disk, this parameter is ignored

System Boot Directory If the Freeway boot ﬁles will be stored in the home directory of the FTP

(or RSH) user account, clear this ﬁeld. Otherwise, enter the full path

name of the boot directory. The default UNIX directory is

/usr/local/freeway/boot. The default VMS directory is

SYS$SYSDEVICE:[FREEWAY.BOOT]. For Windows NT versions earlier

than 4.0, the default directory is c:\freeway\boot. For Windows NT

4.0 or later, use the alias you have set up to point to the

freeway\boot

directory.

To boot from the local disk, set the system boot directory to //

System Boot File Name Enter the system boot ﬁle name for this Freeway. The default is ff

Table 3–1: Freeway System Boot Parameters (Cont’d)

Boot Parameter Description