Installation guide

4: Conﬁguring the Boot Parameters using the Local Console

DC 900-1370E 61

Step 7:

After you have entered the last parameter (

Gateway Inet Interface), the screen displays:

Save modifications?

Enter 'yes <return>' to save modifications.

Enter 'no <return>' to prevent modifications.

If all of the parameters have been entered correctly, enter yy

; otherwise, enter nn

If you enter

, the screen displays the following message, and the system returns to the

Freeway Boot System Main Menu after data storage completes:

<<< Storing Data to IDE Disk >>>

If you enter

, the system returns to the Freeway Boot System Main Menu with no

modiﬁcations to the boot parameters.

Step 8:

Select option 2 at the Freeway Boot System Main Menu (Figure 4–1 on page 56) to

review the current boot parameters. Verify that the changes you entered are correct. If

the changes are incorrect, or you entered

to store data, select option 3 again and

modify the boot parameters to their correct values.

Step 9:

Select option 1 from the Freeway Boot System Main Menu (Figure 4–1 on page 56) on

the Freeway console to perform the system boot.

Note

After the initial system boot, you can telnet or rlogin to Freeway

from the boot server (or from any other computer on the network)

and use the Freeway Interactive Menu for Freeway operations as

described in the Freeway User’s Guide.