Installation guide

60 DC 900-1370E
Freeway 1100/1150 Hardware Installation Guide
Secondary Network
Interface
If the Boot Device is a local area network device (boot server), the
Secondary Network Interface parameter should be cleared, which is
the default.
If the Boot Device is the hard or flash disk, this parameter specifies the
local area network device to be used after Freeway boots. The values
used to define your network interface device are the same as those
defined for the Boot Device parameter on page 58.
Gateway Inet Interface If your Freeway and boot server are on the same network, clear this
parameter, which is the default. If they are on different networks, enter
the IP address of the gateway processor on the Freeway’s network that
provides access to the boot server’s network.
Table 4–2: Flags for Reset Action
Flags Parameter Value Boot Protocol and Reset Action
0x0000 (default)
Upon system reset, wait 7 seconds before autobooting.
0x0004
Upon system reset, display the Freeway Boot System Main Menu.
Do not autoboot.
0x0008
Upon system reset, wait 2 seconds before autobooting.
0x1000
Display version numbers of .mem files downloaded to an ICP
during boot. The Flags word is an inclusive “OR” of the desired bits
for the individual functions; for example, 0x1008 waits 2 seconds
before autobooting and displays the version numbers.
Table 4–1: Freeway System Boot Parameter Descriptions (Cont’d)
Boot Parameter Description