Installation guide

DC 900-1370E 29

Chapter

Getting Started

This manual describes how to install the Freeway 1100/1150 hardware and conﬁgure

the boot parameters. The following is a summary of the complete installation proce-

dure:

1. Install the hardware as described in Chapter 2 of this manual.

2. Install the software onto the boot server as described in the Freeway User’s Guide.

3. If you are using the boot parameter initialization disk, conﬁgure the boot param-

eters as described in Chapter 3 of this manual.

4. If you are using a local console, conﬁgure the boot parameters as described in

Chapter 4 of this manual.

5. Boot the Freeway server.

6. Run the loopback test as described in the Loopback Test Procedures.

7. Customize your installation, if necessary, as described in the Freeway User’s Guide.

8. Familiarize yourself with Freeway operations as described in the Freeway User’s

Guide.