User`s guide

DC 900-1339H 65
Chapter
4
FMP Link Configuration
Options
This chapter describes the various link configuration options that can be defined using
the DLI configuration file described in Section 5.2 on page 102. Alternatively, the link
options can be set using the
dlWrite Configure Link command as described in
Section 3.4.1.4 on page 49.
Table 4–1 lists all the available options in numerical order along with the allowed set-
tings and defaults. The defaults are in effect immediately after the protocol software is
downloaded to the ICP. They remain in effect until you either modify the DLI configu-
ration file and redownload the ICP, or send a
dlWrite Configure Link command.
Note
Link configuration options can be set only when the link being
configured is stopped.
Some of the possible error conditions are discussed in the following sections, as they
relate to using each configuration option. Appendix C explains FMP error handling
and gives a list of errors.