User`s guide

3: FMP DLI Functions
DC 900-1339H 41
Note
When using non-blocking I/O, a dlRead request must always be
queued to avoid loss of data or responses from the ICP (see Step 5
of Table 3–2).
Table 3–2: DLI Call Sequence for FMP (Non-blocking I/O)
1. Call dlInit to initialize the DLI operating environment.
The first parameter is your DLI binary configuration file name.
2. Call dlOpen for each required session (link) to get a session ID.
3. Call dlPoll to confirm the success of each session ID obtained in Step 2.
4. Call dlBufAlloc for all required input and output buffers.
5. Call dlRead to queue the initial read request.
6. Call dlWrite to send requests and data to Freeway (Section 3.4 on page 45).
7. Call dlRead to queue reads to receive responses and data from Freeway (Section 3.5 on
page 60).
8. As I/Os complete and the I/O completion handler is invoked, call dlPoll to confirm the
success of each dlWrite in Step 6 and to accept the data from each dlRead in Step 7.
9. Repeat Step 6 through Step 8 until you are finished writing and reading.
10. Call dlBufFree for all buffers allocated in Step 4.
11. Call dlClose for each session ID obtained in Step 2.
12. Call dlPoll to confirm that each session was closed in Step 11.
13. Call dlTerm to terminate your application’s access to Freeway.