User`s guide

18 DC 900-1349B
BSCDEMO User’s Guide
DISABLE
STOP
Disable a link. Turns off the DTR modem control signal and
shuts down the link transmitter and receiver. Performs the
UNBIND function for Freeway.
/TRACE Disable trace node.
ENABLE
START
Enable a link. Turns on DTR modem control signal and pre-
pares link to transmit and receive data according to the current
configuration. Performs the BIND function for Freeway.
/ID BSCDEMO prompts for the enable ID (upper case only).
Valid SWIFT ID = SWFXX, where X may be any upper-case
character.
/TRACE Enable trace node.
EXIT
QUIT
X
Exit program (or use CTRL/Z).
FLUSH Issue a flush queue command.
HELP /COMMANDS Display a summary of valid BSCDEMO commands.
/PARAMETERS Display a summary of all BSCDEMO link configuration
parameters.
/Pn/Pn…Pn Display a summary of specified BSCDEMO link configuration
parameter(s), where n = parameter number(s).
INHIBIT
TOGGLE
Enable/Inhibit: Works as a toggle switch. With no options
specified, this command displays all current option settings.
/ACK Enable or inhibit automatic sending of a safe store acknowl-
edgment after receipt of ETX. Should be enabled only if safe
store option is configured on. See also SEND/ACK command.
/CONTROL = n Enable or inhibit control node where n = node number (for
Freeway, n must = 17). While enabled, BSCDEMO uses the
prompt: CONTROL>
/DATA Enable or inhibit data display.
/READ Enable or inhibit automatic reads. With read inhibited, a read
command will read only one block. With reads enabled, any
command will read all blocks currently queued for the link.
/WRITE Enable or inhibit delay between writing blocks to the client. If
enabled, the delay time is the current value of the TIMEOUT
command.
Table 1–1: BSCDEMO Commands and Options (Cont’d)
Command Option Description