Installation guide

ManualsBrandsSimpact ManualsComputer equipmentFreeway 1100

100

6: Programming Considerations

DC 900-1564A 95

SLC_ERR_LCI_HLD_MISSING

SLC_ERR_LCI_HLD_PRESENT

In the required Link Characteristics Identiﬁer ﬁeld, the

LCI_HLD_PRESENT bit is not consistent with the conﬁgured level

of SLC network service. This bit must be set to indicate the pres-

ence of High Level Designators (HEX/HEN) on an SLC network

conﬁgured for SLC_HIGH_LEVEL_NETWORK service, but must be

zero on an SLC network conﬁgured for SLC_LOW_LEVEL_NETWORK

service.

SLC_ERR_LCI_LAST_BLOCK_MISSING

The LCI_LAST_BLOCK bit in the LCI must be set to indicate that

the entire message is present.

SLC_ERR_LCI_MISSING

The required Link Characteristics Identiﬁer ﬁeld is not present.

SLC_ERR_MCI_BASE_VALUE

In the required Message Characteristics Identiﬁer ﬁeld, the

MCI_BASE_VALUE bit is not set.

SLC_ERR_MESSAGE_REPEAT_ABORTED

Automatic message retransmission initiated by a T6 time-out

condition cannot be achieved because SLC block buffers previ-

ously submitted for transmission are missing in action. This

error can occur due to non-optimal conﬁguration of items

SLC_T1_CFG through SLC_T11_CFG, or due to intermittent errors

on one channel when SLC_BLOCK_SCATTER_CFG is enabled.

SLC_ERR_MESSAGE_REPEAT_LIMIT

Automatic retransmission of the message has completed the

conﬁgured number of attempts without detecting the required

acknowledgment.

SLC_ERR_PORT_XMIT_FAILURE

SLC block transmission did not complete within the conﬁgured

SLC_T11_CFG time limit.

SLC_ERR_PROTCIRCUIT

The speciﬁed usProtCircuitID ﬁeld is not valid.

SLC_ERR_PROTCOMMAND

The speciﬁed usProtCommand ﬁeld is not valid.

SLC_ERR_PROTLINKID

The speciﬁed usProtLinkID ﬁeld is not valid.

SLC_ERR_PROTMODIFIER

The speciﬁed iProtModifier ﬁeld is not valid.

SLC_ERR_PROTSESSION

The speciﬁed usProtSessionID ﬁeld is not valid.

SLC_ERR_SEND

The requested command is not valid. The iProtModifier ﬁeld in

a DLI_PROT_SAFE_STORE_ACK command speciﬁes an invalid AML,

or the value indicated in the usProtCommand ﬁeld is inconsistent

with the SLC_SERVICE_CFG conﬁguration.

SLC_ERR_SEND_BIND_REQUIRED

The requested command cannot be executed until after success-

ful completion of a DLI_ICP_CMD_BIND command.

SLC_ERR_SEND_CFG_INVALID

The requested command is not permitted under the current

conﬁguration.

Table 6–6: Error Codes Reported in the iICPStatus Field (Cont’d)