User Manual

SmartRelay: SREL, SREL.ZK, SREL.ADV
Page 9
5.0 Installation
 Switch off the supply voltage (if necessary, pull out the plug or disconnect the
battery).
 Connect all cables to the terminals provided on the SmartRelay (see
Connection Assignments on the following page)
If you are connecting a direct current power supply, make sure that you
get the polarity correct.
 Switch on the supply voltage (if necessary, insert the plug or connect the
battery).
 Verify the function of the SmartRelay with a transponder in the condition as
received from the factory.
 Program the SmartRelay with the SimonsVoss software (we recommend
software version LDB.EXE 1.40 or later).
 Use a transponder that is now authorized in order to test the functioning of the
SmartRelay again.