Safety Instructions

Biometric Transponder: TRA.FP.INF2
Page 6
2.3 How the transponder works
You can interrupt the action in each mode by pressing the button briefly to change to Standby.
2.4 "Learn" state: start-up, scanning in fingerprints
Initial start-up - scanning in the first 2 fingerprints (Administrator fingerprints)
To start the Biometric Transponder, two "Administrator fingerprints" need to be scanned in
first. We recommend that a fingerprint from the left and right hand of one person, the
administrator (e.g. safety officer) is used for this; however, you can also use one finger from
two different people.
Stand-by mode: LED not illuminated
Briefly press button once, then release
Recognize mode: LED flashes green
Learn mode: LED flashes yellow
Delete state: LED flashes red
Drag finger across sensor
Transponder triggered
Press button and hold
down for 3 sec.
New finger is memorized
Press button and hold
down for 3 sec.
Drag Administrator finger
once over sensor and new
finger (User finger) 3 times
over sensor.
Draw user finger once
across sensor
Draw Administrator finger
once across sensor
All fingerprints are deleted
Only user fingerprint is
deleted