Product manual

PRODUCT MANUAL

TRANSPONDER 3064

3.6 Fire service key tube transponder

This transponder features a narrower casing (33 mm), so that it can be stored in a

standardised fire service key tube safe.

3.7 G2 battery replacement transponder

A G2 battery replacement transponder can be created in the LSM programme for G2

locking systems. This transponder can be used to deactivate freeze mode by activat-

ing it on the cylinder. The door can then be opened with an authorised transponder.

This means there is no need to take the programming device to the lock concerned.

! In the case of an active battery warning, batteries are still used each time the

door is opened. This may lead to the batteries being fully discharged if the tran-

sponder is not used for its intended purpose. The batteries must be replaced

immediately in such cases.

4 EXPLOSION PROTECTION TRANSPONDER

4.1 General information

This transponder is a special product which can be carried and used in Zone 1 poten-

tially explosive areas. Zone 1 refers to an area where a potentially explosive atmos-

phere sometimes occurs during day-to-day operations. The following aspects must be

taken into account:

 The casing must not be opened.

 Only SimonsVoss Technologies GmbH may change the battery, unlike Stand-

ard Transponder 3064.

 As a general rule, users must comply with explosion protection regulations,

such as the German Operating Regulations BGR132, when using the device.

4.2 Industrial standards

This transponder has been tested in accordance with applicable explosion protection

standards. Refer to the following for further information:

 Directive 94/9/EC

 DIN EN 60079-0 (Electrical equipment for potentially explosive atmospheres)

 DIN EN 60079-11 (Intrinsic safety 'i')

4.3 Classification

The transponder is classified as follows:

 Explosion Protection Zone 1

 Intrinsic safety ib

 Explosion Group IIC

 Temperature class T3