Unit installation

Q3007 Biometric Transponder
Page 10
3.0 "Delete" mode: deleting fingerprints
Both individually scanned fingerprints and all the fingerprints can be deleted from the
memory.
If normal fingerprints (not Administrator fingerprints) are deleted, the other fingers that
have been scanned in are not deleted. No Administrator fingerprint is needed to do
this (any normal user can delete his own fingerprint).
If one of the two Administrator fingerprints is deleted, all the fingerprints are
automatically deleted. The first two fingerprints that are then scanned in are
automatically the Administrator fingerprints again.
Fingerprints are deleted as follows:
1. Briefly press the transponder button and wait until the LED flashes green.
2. Then press the button again and hold it pressed for at least 3 seconds until the
LED flashes yellow. Release the button.
3. Press the button again and hold it pressed for at least 3 seconds until the LED
flashes red. Release the button. You are now in the "Delete" state.
4. Drag finger across sensor.
5. If the first recognition attempt was successful, the LED flashes green. If the
fingerprint is a normal one (user fingerprint), only this fingerprint is deleted; if it
was one of the two Administrator fingerprints, then all the fingerprints are deleted.
Deleting all the fingerprints can take up to 15 seconds. During this time, the diode
flashes red every 2 seconds.
6. If the LED flashes yellow, the recognition attempt was not successful. You can
now try three more times. If these all fail, the Q3007 automatically returns to
Standby mode.
4.0 Transparent mode
It is possible to switch the Biometric Transponder to what is called Transparent mode.
In this state, the biometric inquiry is interrupted for 5 minutes and the Biometric
Transponder can be used as a normal transponder (doors can be opened simply by
pressing a button). At the end of 5 minutes or so, the Biometric Transponder returns
to Standby mode.
Transparent mode is required, for example, for setting/cancelling alarms (if an SV
Shuntlock VdS is installed) or if several doors need to be passed through in a short
time.