Unit installation

Transponder 3064
Page 3
1.0 Method of Operation
1.1 General
The Transponder 3064 is a digital “key” that is programmed with the locking plan
software and that works over radio transmission with no physical contact. All
functions, for example, opening and closing doors, gates, barriers, furniture locks,
etc., are carried out by pressing a button. Communication with the digital components
(cylinder, Smart Relay and activation unit) takes place by sending and receiving
constantly changing crypto codes, which makes misuse practically impossible.
Since the System 3060 works with active transponder technology, the transponder
has its own voltage source (battery) available. The advantage in comparison to
passive technologies lies in the smaller energy requirements of the cylinder and the
larger range.
In order to trigger an action, hold the transponder near the digital locking (refer to the
separate chapters for information on maximum transponder ranges) and then press
the transponder button. Provided that the transponder is authorised for this digital
locking, the desired action, for example, opening or locking the door, can be carried
out.
The housing of the transponder is protected against splash water. However it is not
waterproof!
Each transponder can be used in three different, mutually independent locking
systems (assuming that no validity areas were programmed). Each locking system
has its own password and is administered separately.
Example:
Company Branch Private home
900 lockings 85 lockings 3 lockings