Manualshelf

Unit installation

ManualsBrandsSimons Voss Technologies ManualsGadgetsPalm LDB Version 1.40
31323334353637383940
Digital Half Cylinder
Page 12
the flange holds securely. To find the exact position quickly, the flat surfaces
of the pipe and flange have black markings that must line up.
3. Put the flange on the end of the pipe without screwing it in. The side with the
small outside diameter points towards the door. The fore-part of the pipe,
which sticks out of the profile, contains two slots in which you can position the
special tool (offset 90° to the lengthwise slot which guides the cable). The
narrow end of the installation tool can move into this slot. This ensures that
the pipe cannot twist.
4. The pipe should not turn during the following steps (see Point 3). Lightly screw
on the flange until it reaches the stop and the markings line up. In this
position, tighten the two setscrews with the Allen key (1.5 mm) so that they
center in the indentations of the pipe. Then tighten both setscrews securely.
Please check whether the setscrews are really tightly screwed, because this is
important for correct functioning!
5. 5Fix the electronics module to the flange with the Allen screws that are
parallel to the battery (same Allen key). Make sure that the cable is not
pinched.
6. Connect the cable to the electronics socket and lay it so that it is flat on the
electronics covering and not in the way when screwing on the knob (danger of
pinching).
7. Use an authorised transponder to couple the half cylinder and tightly screw
the knob in until the stop. While doing this, you must firmly hold the catch with
your hand if the half cylinder is not installed. If the half cylinder is installed, the
catch is held by the stop within the lock.
8. Firmly hold the knob and use the special tool for half cylinders to firmly screw
the locknut onto the knob.
6.6 Perform Function Test
1. Operate an authorised transponder and turn the knob in the lock and open
directions when the door is open. The knob must turn easily.
2. Close the door and repeat the process. If the locking cylinder is stiff, you must
align the door or correct the edge plate.