Unit installation

Digital Half Cylinder
Page 8
6.0 Installation Instructions
6.1 General Information
Only trained and authorised personnel are permitted to perform the installation. The
battery used in the cylinder can present a risk of fire and burns if not handled
correctly! Do not charge, open, heat to more than 100° C (212° F) or burn! Do not
short-circuit! When installing the digital half cylinder, make sure that there are no
sources of interference in the vicinity. You should install half cylinders at least 0.5 m
(approximately 1.5 feet) from one another and Smart Relays or activation units at a
distance of at least 1.5 m (approximately 5 feet). The PC housing of the half cylinder
is not allowed to stick out into the exterior area more than 3 mm. If necessary, attach
a profile cylinder rosette. Furthermore, you must ensure that no water can penetrate
into the cylinder in the area of the catch.
6.2 Programming a Half Cylinder
You must program the digital locking cylinder and accompanying transponders in the
locking plan before you install them. Please refer to the Software Operating
Instructions for more detailed information.
& The locking cylinders are delivered in so-called storage mode, which means
that no communication is possible with the transponder (exception:
programming transponder). You can also use software and the programming
device to remove the storage mode. Please refer to the Software Operating
Instructions for more detailed information.
6.3 Installing in Doors
Insert the cylinder through the lock from the outside of the door towards the inside
and secure it with the lock screw.
& Never hit against the knobs during installation. Do not bring the cylinder into
contact with oil, paint or acid.