Technical data

SMART RELAY SREL, SREL.ZK, SREL.ADV

5.0 Installation

 Switch off the power supply (disconnect the plug or battery if necessary).

 Connect all cables to their designated terminals on the Smart Relay (see Ter-

minal Assignment on the next page).

It is essential to ensure the polarity is correct if you connect a DC mains

adapter.

 You will achieve the largest reader range possible if the Smart Relay antennas

are aligned in parallel to that of the transponder.

 Switch on the power supply (connect the plug or battery if required).

 Check that Smart Relay functions with a transponder in its as-delivered condi-

tion.

 Programme Smart Relay with the SimonsVoss software (we recommend soft-

ware versions LDB. 1.50a or higher, or LSM 2.2 or higher).

 Check that Smart Relay functions again using a newly authorised trans-

ponder.