Technical data

SMART RELAY SREL, SREL.ZK, SREL.ADV
4
1.0 Important instructions
Safety Instruction:
Warning: – The batteries used in this product may pose a fire or burn hazard if
handled incorrectly. Do not recharge, open or burn these batteries, or heat
them to over 100°C.
Specialist knowledge in door mechanics, door approvals, electronic system installa-
tion and the use of SimonsVoss software is required when installing a SimonsVoss
Smart Relay. This is why only trained specialists may install Smart Relay.
SimonsVoss Technologies AG accepts no liability for damage caused by incorrect in-
stallation.
Access through a door may be blocked due to defective or incorrectly installed Smart
Relays. SimonsVoss AG is not liable for consequences of incorrect installation,
such as blocked access to injured persons or those at risk, physical damage or any
other losses.
If Smart Relays are placed in storage for longer than a week, the backup battery is to
be removed.
Smart Relays must be installed in compliance with ESD (electrostatic discharge)
guidelines. You should particularly ensure that you do not touch circuit boards and
their integrated circuits.
In the event of doubt, original German language version applies.
2.0 Product Description
The SimonsVoss Smart Relay is an electronic switch which can be activated with a
SimonsVoss ID transponder. The authorisation for transponders which are permitted
to operate Smart Relay can be configured using the SimonsVoss software. Smart Re-
lay thus fulfils the function of an access control reader.