Operating instructions

Manual – LDB 1.5
Page 85
85
9.0 Block lock components
9.1 Arming unit (SSM and SSS)
The arming unit is used to arm the alarm system. If you would like to add the block
lock components at a later stage, open your Lock System using the password.
Otherwise, create a new Lock Plan.
Choose New > Lock. Assign a name for the arming unit (i.e. Alarm system).
In the Type box, select Control unit. Click OK & Exit, or OK & Next if you would like
to set up more arming units.
To avoid mutual interference, place the arming unit in a separate Lock Plan
(does not apply to VdS components).
In the Lock Plan, place a cross by the member of staff who is authorized to switch the
alarm system on and off.
Note: In such cases, the transponders do not require reprogramming.
Authorize your Lock System and program the arming unit under Programming >
Lock.