Operating instructions

Manual – LDB 1.5
Page 83
83
Once successfully programmed, the window can be closed by clicking OK and then
Exit.
What you do from there depends on whether your Lock System is operated
in Overlay Mode or not.
If the Lock System is operated in Overlay Mode, you can conduct programming using
the spare transponder. Take it to the locks which the lost transponder was authorized
to operate. In this example this includes Main entrance, barrier, entrance building 402
1st floor, Office 101, Office 102, Entrance to building and 402 2nd floor.
At each lock, press the transponder button so that the lock responds. The data of the
replacement transponder will be transmitted to the lock, and the lost transponder
automatically deleted.
In the Lock Plan, the programming symbol remains until the lock is programmed or
data (the transponder list) is retrieved from it using the SmartCD configuration tool.
If the System is not being operated in Overlay Mode, then reprogramming can only be
performed using the configuration tool. Go to the locks that require programming.
Again, in this example this includes Main entrance, barrier, entrance building 402 1st
floor, Office 101, Office 102, Entrance to building and 402 2nd floor.
Click on the lock concerned so that it is highlighted.
Choose Programming and Lock. Position the configuration tool in front of the lock
and click OK. Program the other locks in the same way. To close the window, click
the Exit button.