Operating instructions

Manual – LDB 1.5
Page 80
80
If you would also like to delete the access audit log, then check Delete Access List.
Click on Reset. The programming is deleted, and the component is now in the state
in which it was originally supplied and is available for reprogramming. In the Lock
Plan, the yellow programming symbol reappears and the crosses showing selected
transponders are changed from bold to thin. If you would like to remove the lock from
the Lock Plan, then click on it and choose Edit > Cut.
8.3 Copying a transponder
You can make multiple copies of a transponder. Select the transponder you would
like to copy so that it is highlighted. Choose Programming > Transponder. Confirm
the transponder programming if necessary. Next, click the Program button, and
briefly press the button on the transponder.
The locks do not need to be reprogrammed after this.
The number of copies to be set up can be defined in the transponder’s Properties
dialog box. Select the transponder and choose Edit > Properties. Select the Lock
Systems tab. The number of copies can be entered near the bottom of the box.