Operating instructions

Manual – LDB 1.5
Page 79
79
8.0 Replacing a component
8.1 Replacing a lock
If you replace a lock that cannot be reset, then the software will not be able to
program the new lock at first. First you have to reset the lock in the Lock System:
Open your Lock System for modification. Click on the lock (i.e. Main entrance) which
you would like to replace so that it is highlighted in the Lock System. Choose Edit >
Properties. Select the Data tab, and then click on the button entitled Lock has been
reset.
The current figures will return to 0 in the Lock System. Confirm with OK. You do not
need to perform this operation (nor should you) if the ‘old’ lock you are replacing can
be reset; after resetting, the new lock can be programmed immediately. Approve the
Lock System and program the lock.
8.2 Resetting a lock
Position the Configuration tool in front of the lock concerned. Choose Programming
> Reset lock. The lock’s data is retrieved to begin with, and a window opens
containing its information. Enter your password (i.e. test) for the Lock System. The
password is shown as asterisks when entered so it can not be seen by anyone
looking over your shoulder.