Operating instructions

Manual – LDB 1.5
Page 63
63
If the Output Modules are programmed using a PDA, then those modules are
not offered when exporting the data to the PDA. They are only exported as a
unit together with the SmartRelay.
SmartOutput Modules in a network
If the SmartRelay and associated Output Modules are to be integrated into a
SimonsVoss network, then all of the module outputs must always be assigned to the
same Lock Node.
The software generally attempts to do this automatically. Should this fail to
happen, then you will have to update the affected nodes and locks. Contact an
authorized SimonsVoss representative to request assistance with this.
Replacing a defective SmartOutput Module
Should you need to replace a defective SmartOutput Module at any stage, you will
have to reset the data associated with that SmartOutput Module in your Lock System.
To do this, go to the Lock properties of the lock (output) of the associated module
and, in the Data tab, click the button labelled ‘Lock has been reset’.
Resetting the module causes a programming flash to appear behind the locks
associated with the module, and the authorization crosses appear ‘thin’.