Operating instructions

Manual – LDB 1.5
Page 62
62
Moving a SmartRelay with SmartOutput Modules
If you want to move the SmartOutput Modules within a Lock System – for example to
another area – then you must always move all of the SmartOutput Modules along with
the associated SmartRelay, since these components form a single unit from the point
of view of the software.
Deleting the SmartRelay with SmartOutput Modules
If you need to remove a SmartRelay from the Lock System, then all of the
SmartOutput Modules that are allocated to this SmartRelay will also be automatically
deleted.
Unlike the deletion of a normal lock, this action can always be undone.
Programming the SmartOutput Modules
The SmartOutput Modules can only be programmed via the associated SmartRelay
(only the SmartRelay has the radio communication interface needed). To ensure that
all of the changes from the Lock System are transmitted to the various Modules, you
should always select the ‘Program all module outputs on the SmartRelay’ option
when programming the SmartRelay.
This procedure can take quite a long time, depending on the number of Output
Modules, since all of the locks (outputs) must be programmed one after the
other in one single programming operation.