Operating instructions

Manual – LDB 1.5

Page 54

4.13.3 No acoustic programming confirmations

If you do not want the connected buzzer / beeper to respond when the SmartRelay is

programmed, then check this box.

4.14 Replace control unit with SmartRelay

If you need to replace a control unit with a SmartRelay, then observe the

following:

1. Reset the current status of the lock in the Lock System (see Chapter 8 of the

Software Manual).

2. Change the type from control unit to SmartRelay.

3. Reprogram the SmartRelay.

4. Adjust the configuration if necessary.

It is generally not possible to program locks that differ in terms of hardware and

software.

4.15 SmartOutput Modules (SOM) – Extension modules

Setting up SmartOutput Modules

If SmartOutput Modules are to be used in your Lock System (for controlling an

elevator, for example), then you will have to create a new lock in the software and

define it as a SmartRelay, since the Modules can only be run in conjunction with a

SmartRelay Advanced.