Operating instructions

Manual – LDB 1.5
Page 26
26
Hold the transponder in front of the Config Device, click Program, and briefly press
the button on the transponder.
Warning: Make sure that there are no sources of interference nearby.
Warning: Transponders that are not authorized cannot be programmed.
Confirm successful execution with OK. The yellow programming flash next to the
transponder name will disappear signifying that its programming is now up to date.
You can continue to program transponders by choosing the next one in the open
window. If desired, the software can move automatically to the next transponder
following successful programming. To activate this, check the box next to Move to
next transponder following programming. Click on OK and program the next
transponder as described above. Once you have programmed all the transponders,
click on Exit.
2.10 Adding locks