Operating instructions

Manual – LDB 1.5
Page 127
127
15.10 Input/output
This is where you can adjust the inputs and outputs of the Lock Node.
If you would like to activate the output, check Set output, and to deactivate it check
Reset output. If you change this setting, you have to subsequently reprogram the
Lock Node. To do this, click the Program button.
If you would like the network node to constantly check its inputs, then check React to
inputs, and program the Lock Node.
15.11 Messages
This is where you obtain information about the status of the Lock Node’s inputs and
outputs.
You must program the network nodes so that they can respond to inputs.
If the table contains the message Input status change; Input 1 or Input status change;
Input 2, then that network node input is closed. If the message Input status change
appears, then the contact is open again.
This list is not updated automatically; you must always click the Update button
before reading it.
To delete a message, select it and press Delete.
You can use the Filter to define which network nodes are shown in the list and which
are not: