Operating instructions

Manual – LDB 1.5
Page 126
126
15.8 Removing network nodes
Select the lock whose network node you would like to remove. Choose Options >
Network setup, then click the Configure Network Nodes button. Enter a zero (0)
next to Group ID and Member ID, then click Manual configuration. Confirm the
security message with OK. The software will then delete the network node.
15.9 Configuring attenuation
If structural circumstances mean that the Lock Node is installed less than the
minimum distance away from the digital lock, then the Lock Node’s transmission
output can be reduced so that it does not overload the lock.
In Network setup, click the Configure attenuation button. The Lock Node will
normally set itself to the distance which exists. However, if you continue to receive
transmission errors, select manual adjustment. Set the attenuation factor. 0
represents no attenuation and 7 the highest possible reduction. Enter the Lock Node
at which the transmission output is to be reduced.
Then click Run.