Operating instructions

Manual – LDB 1.5
Page 10
10
1.3 Testing the Configuration tool
You can test the Configuration tool you have connected at Programming > Check
Programming Interface. The Configuration tool will respond with its software
version: Config Device SW 2.7 or 2.8; PalmCD SW 8.6 or 8.7; PalmCD2 SW 9.1–9.3;
SmartCD SW 9.6.0.15 or higher; CentralNode SW 1.0. The term ‘Configuration tool’
used in this document relates to all of these devices. Any variations in the way these
are handled will be described, or can be found in the latest versions of the appropriate
manuals.
Confirm with OK.
If the Configuration tool does not respond, check to see if the port is blocked by
another program (such as HotSync Manager) or set it to another COM port. You can
choose from four serial ports; settings can be made at Options > Comport.... The
COM1 port is set by default.
1.4 Current software version
You can display this by clicking on the question mark (?) and then About LDB....
Warning: If an older version of the software (< 1.50) is installed, please contact
your retailer or SimonsVoss directly. You can download the latest version of the