Unit installation

Digital Locking Cylinder 3061 VdS
Page 8
6.4 Inserting the Digital Cylinder Into the Lock
First turn the lock pin until it is pointing straight down. Then insert the Digital Locking
Cylinder through the lock so that the inner knob (long knob) points toward the inside
of the door. Fasten the cylinder with the lock screw included in the delivery
Never hit against the knobs during installation. Do not bring the cylinder into contact
with oil, paint or acid.
6.5 Screw On the Outer Knob
Screw the outer knob on the screw thread, fixing it in position with your fingers if
necessary. Then operate the transponder. Hold the inner knob still and tighten the
outer knob solidly. Finally, tightly screw the setscrew with the Allan key.
6.6 Perform Function Test
1. With the door open, turn the inner knob in the locking and opening directions.
The knob must turn easily.
2. Close the door and repeat the process. If the locking cylinder is stiff, you must
align the door or correct the edge plate.
3. Then perform the same test on the outer knob. To do this, operate an
authorised transponder near the cylinder.
7.0 Potential Applications
7.1 General Information
The Digital Locking Cylinder fits locks for Euro Profile Cylinders that meet DIN 18254
specifications.
7.2 Fire Protection Doors
It is possible to install the locking cylinder in fire protection doors. In this case, use the
Locking Cylinder Version FH. The approval for a fire protection door is always
unaffected by the locking cylinder.
7.3 SLP Locks
The Digital Locking Cylinder 3061 FD is used for applications of this type. The Digital
Locking Cylinder 3061 VdS does not have approval for SLP doors at this time. See
the “Digital Locking Cylinder 3061” manual Æ “Possible Applications.