Unit installation

PinCode Keypad 3068
Page 8
4.0 Programming PINs
The Master PIN required for all programming procedures is defined by the user (e.g.
the System Administrator). Please keep it safe and inaccessible to unauthorised
persons, since the Master PIN is required for all programming procedures.
4.1 First Start-up
For the first start-up, the safety of your locking system requires that you program at
least one PIN. Only after the PinCode Keypad has been programmed can it be gua-
ranteed that only authorised users receive access.
Proceed as follows:
1. Press the "0" to change to programming mode.
2. Enter the "master PIN ".
3. Select the PIN that you want to program; in this case, press "1" for "PIN 1".
4. Enter the length of the PIN (you can choose a number with from 4-8 digits).
5. Enter the "PIN"
6. If the input was correct, the PIN is saved and confirmed.
A PIN is not permitted to begin with "0" and you may not assign the same PIN more
than once. The master PIN is used only for programming the PIN. It is not possible to
operate lockings with the master PIN.
4.2 Programming Additional PINs.
1. To program additional PINs, please proceed as follows: Press the "0" to change
to programming mode.
2. Enter the "master PIN".
3. Press
• "2" for "PIN 2" or
• "3" for "PIN 3".
4. Enter the length of the PIN (you can choose a number with from 4-8 digits).
5. Enter the corresponding "PIN".
6. f the input was correct, the PIN is saved and confirmed.
Attention:
It is not possible to enter programming mode when there is a battery
warning. This means that when the battery is weak, you cannot change or delete a
PIN. Programming mode will only be available again after you have successfully
changed the battery (see the section "Battery Replacement).