Unit installation

MANUAL - BIOMETRIC READER Q3008
Page 21
21
15.0 Replacing the battery
Generally speaking, the battery should only be replaced by a trained specialist. To
open the housing you will need a Torx key of size TX6. Please proceed as follows:
1. Fully unscrew the two screws from the base of the housing.
2. Remove the front of the housing.
3. Remove the battery from the holder.
4. Insert the new battery, making sure that the positive terminal is to the right; refer
to markings on circuit board. (Please note: polarity MUST be correct!).
5. Reassemble the housing.
6. Screw the two screws back into the base of the housing.
After the battery has been changed, all functions will be available again.
When replacing the battery it is essential to ensure that no water can penetrate into
the housing and no electronic parts come into contact with water.
When replacing the battery, and immediately after inserting the battery, be careful not
to touch the sensor or finger guide. This could lead to a loss of locking system data.
16.0 Assembly
Generally speaking, assembly should only be performed by a trained specialist. To
mount the biometric reader on a wall, near the lock it is intended to open, you can use
the screws (including dowels) supplied. To open the housing you will need a Torx key
of size TX6. Please proceed as follows:
1. Fully unscrew the two screws from the base of the housing.
2. Remove the front of the housing. Be very careful not to drop the transponder or
subject it to any other sudden impact.
3. Drill the appropriate holes in the wall, using the rear panel of the biometric reader
as a drilling template if required.
4. Attach the rear panel to the wall using the screws.
5. Reassemble the housing.
6. Screw the two screws back into the base of the housing.
When assembling the unit it is essential to ensure that the sealing ring fits properly,
that no water can penetrate into the housing and no electronic parts come into
contact with water.