Unit installation

MANUAL - BIOMETRIC READER Q3008
Page 19
19
11.6 Resetting the biometric reader
To delete all stored fingerprints from the Q3008 biometric reader at the same time
(including the locking system data), or if you want to exit master finger mode, you
need to delete the complete fingerprint database and reset all locking system data.
Please proceed as follows:
1. Open the locking plan with the locking plan software.
2. Select the appropriate biometric reader.
3. Connect the SmartCD to the PC and bring within communication range of the
‘biometric reader’.
4. Highlight the biometric reader and launch ‘Programming Æ Reset lock’ in the
programming software.
5. Once the lock has been successfully programmed, this is indicated by a pop-up
window.
The biometric reader is now back in its original state and can be used for a different
locking system.
12.0 Manipulation alarm
After 15 failed attempts, i.e. attempts to operate the biometric reader with a non-
programmed fingerprint, the biometric reader reports a manipulation attempt. After
each failed recognition, the LED will then flash red for 60 seconds. No fingers will be
accepted during this time. Following correct recognition of a fingerprint, the
manipulation counter is reset to zero.