Unit installation

MANUAL - BIOMETRIC READER Q3008
Page 15
15
9.0 Deleting all fingerprints
Do not undertake any programming after a battery warning. Replace the battery
before proceeding. Refer to chapter 15.0 Replacing the battery.
To delete all stored fingerprints from the Q3008 biometric reader at the same time,
you need to completely reset the device. Please proceed as follows:
1. Open the locking plan with the SimonsVoss software.
2. Export the locking plan (pocket PC).
3. Bring the SmartCD into the communication range of the biometric reader.
4. Click on the ‘Select‘ function.
5. Select ‘Biometric reader’.
6. Select the ‘Read‘ function.
7. Select ‘Reset‘ and confirm by selecting ‘Execute’.
8. Enter the password for the locking system or take ‘From the database’ and click
on ‘Start’.
9. Re-import the locking plan.
10.0 Reading the biometric reader
It is possible at any time to read the biometric reader and identify programmed
transponders using the SimonsVoss locking plan software.
Please proceed as follows:
1. Open the locking plan with the SimonsVoss software.
2. Export the locking plan (pocket PC).
3. Bring the SmartCD into the communication range of the biometric reader.
4. Click on the ‘Select‘ box.
5. Select the biometric reader.
6. Start the ‘Read lock’ function in the SimonsVoss SmartLSM.