Unit installation

MANUAL - BIOMETRIC READER Q3008
Page 13
13
6.0 Replacing fingerprints
You can replace existing fingerprints with new ones at any point, for example if an
employee has left the company or no longer requires access through a certain door.
Do not undertake any programming after a battery warning. Replace the battery
before proceeding. Refer to chapter 15.0 Replacing the battery.
Please proceed as follows:
1. Open the locking plan with the SimonsVoss software.
2. Export the locking plan (pocket PC).
3. Bring the SmartCD into the communication range of the biometric reader.
4. In SmartLSM, launch the ‘Read’ locks function.
5. Select ‘Modify transponder‘ and start the function by selecting ‘Execute’.
6. Select the appropriate transponder (biometric reader user) and launch the
‘Programming’ function.
7. While the transponder is being programmed, the biometric reader automatically
switches to Learn mode (LED flashes yellow), and you will be asked to draw
your finger over the finger guide.
8. Draw the new finger over the sensor.
9. If the fingerprint is recognised, the LED gives two long flashes in green.
10. If programming was successful, the message “Programming successful“
appears in the SmartLSM. The fingerprint has been successfully stored.
11. After you import the locking plan the programming lightning symbols disappear,
both from the programmed transponder (biometric reader user) and the
biometric reader (if all transponders (biometric reader users) have been
programmed).
To replace additional fingerprints, repeat from step 3.