Unit installation

LON – Network 3065
Page 10
In order to guarantee proper radio transmission, you should maintain the following
distances between the LockNode and the digital locking:
Minimum Maximum
LockNode to the digital locking cylinder 10 cm 30 cm
LockNode to the digital control unit 20 cm 100 cm
LockNode to the Smart Relay 50 cm 100 cm
LockNode to the activation unit 20 cm 100 cm
 For distances between the LockNode and the control unit of less than
20 cm or less than 50 cm between the LockNode and the Smart Relay, we
ask that you contact your dealer or the manufacturer.
 The LockNodes must be built according to the layout plan drawn up during
planning. The plan indicates the position of the LockNodes and specifies
the group and member IDs. This information is printed on the LockNode. All
necessary wires must be connected to the LockNode terminal strip.
(Network cable connection: terminals 1 and 2. The polarity is not relevant).
4.3 Antenna Extender
Since the standard range of the LockNode is not sufficient for double doors, a
LockNode with an extended antenna must be used in this case. The extended
antenna is mounted in the door (in the immediate vicinity of the cylinder) and
connected to the LockNode via a cable transfer on the door.
 To guarantee that the radio transmission functions correctly, we
recommend that you provide a plastic inspection flap at the level of the
antenna.
 You can always attain wider ranges by using FH versions.
 Make sure that the cable of the extended antenna is exactly the length
needed. You should always cut off any extra cable length.